Cured foam should not be exposed to temperatures in excess of 240☏. The can should not be exposed to temperatures more than 120☏. Best results if used when product temperature ranges from 60-90☏ (15-32☌).If the can sputters, simply shake the can while held upside down. Shake vigorously for a minimum of 60 seconds.
Great stuff pest block skin#
It will not harm your skin and will wear off over time. If the foam has hardened, there is no solvent that will remove it. If the foam has not cured or hardened, use fingernail polish remover (with acetone) a polyglycol-based skin cleanser or corn oil may be effective. Q.How do I get Great Stuff™ foam off of my skin? Great Stuff™ Pestblock and Great Stuff Pro™ Pestblock expand to fill, seal and insulate gaps up to 1" (25 mm), forming a long-lasting, airtight and water-resistant barrier. They BLOCK insects and pests from entering the home by sealing gaps, cracks and holes where they commonly enter. We have specifically designed a variation of our Great Stuff™ foam to solve this issue, Great Stuff™ Pestblock and Great Stuff Pro™ Pestblock. Rodents and small animals, if determined enough, can chew through many materials, including Great Stuff™ foam. Q.Can mice, insects or other pests chew through Great Stuff™ foam? Remove the can from the dispensing gun and spray into waste receptacle without the can until the gun is completely empty. Press the trigger to flush the foam into waste receptable until only the cleaner is visible.Īllow gun to sit for several minutes and repeat with a second flush.
Great stuff pest block install#
Invert the can and install the cleaner onto the dispensing gun. Unscrew used Great Stuff Pro™ from dispensing gun.Ĭlean the gun basket and tip by generously spraying and removing uncured foam with Great Stuff™ Foam Cleaner. Q.Can I clean the Great Stuff™ Black gun? Extinguish any open flames before applying foam.When applying Great Stuff™ Polyurethane Foam, make sure to wear PPE, including proper eye protection, gloves, and long sleeve clothing.Store upright with a foam dispensing gun attached.Lastly, test the bead size before applying. Then, pull the trigger to fill the gun with foam, dispensing excess foam into an appropriate waste receptacle.
With the can secured, set your desired bead size by adjusting the flow control knob on the back of the gun (bead can be adjusted from 1/8"-3"). Tightly secure the can onto the gun before opening the valve to ensure that the can is properly threaded onto the gun basket to prevent leaks.
0 kommentar(er)
